Blown-in insulation in Cerritos CA - an even layer over your whole ceiling
Hot upstairs rooms and a climbing power bill usually trace back to a thin attic. We seal the gaps first, then fill it evenly.
Does my Cerritos attic need blown-in insulation?
Blown-in insulation in Cerritos is loose fill, usually cellulose or fiberglass, blown through a hose across the attic side of your ceiling until it covers everything out to the top of the outside walls, so less of the attic's heat makes it down into your rooms.
If the upstairs stays hot after the AC has run all afternoon, or the room over the garage never feels right, the attic is usually where I'd look first. I spent years as a heating and air tech, and I kept finding good equipment working hard under insulation that was thin, crushed or missing. We're Caliber Cerritos Spray Foam Insulation, fully licensed and insured, based in Cerritos and working in the cities around it in Los Angeles and Orange counties.
The price moves with the size of the attic, how many inches are already up there, how much sealing the ceiling needs first and which material you pick. The schedule mostly turns on city approval and how easy the attic is to get into, and your written estimate lists each step in the order we'd do it so you can see where the money goes.
- Covers the attic floor out to the top of the outside walls, edges as deep as the middle.
- Goes over a dry, clean layer that's already there, or over a bare ceiling with nothing left.
- Starts with sealing the gaps around pipes, wires, lights and the hatch before any fill goes in.
What happens after you call us about blown-in insulation?
I come out to every estimate myself, and our installers do the work. Here's how a blown-in job goes in Cerritos, from your first call to the walk-through at the end.
Call or send a message
You call (562) 307-9067 or use the form, and we get back to you to set up a visit. It helps to tell us where the attic access is, whether that's a hatch in a closet or one in the garage.
I measure and write it up
I go through the attic, measure the inches already up there, check the vents, lights and framing, and take photos. You get a written estimate that lists each step in the order we'd do it, so the numbers match the house you actually have.
Our installers do the work
On install day our crew protects the house, seals the ceiling gaps and blows in the new layer. In Cerritos that work happens between 7 a.m. and 6 p.m. on weekdays or 10 a.m. and 5 p.m. on Saturdays, with no work on Sundays or city holidays unless the city approves otherwise in writing.
We go over it together
Before we call it done, I check the depth and coverage myself and walk you through the finished job. If something doesn't look right to either of us, that's when we fix it.
Attic insulation work, from sealed gaps to finished fill
These photos show the kind of attic work this trade does, from sealing around pipes and lights to blowing loose fill. They're general pictures of the work, not jobs from a particular house.
A gray machine stands on a white plastic vapor barrier covering a crawl space floor beneath wooden joists.
A worker sprays foam insulation into a wall cavity between exposed wooden studs.
Worker in protective suit sprays foam insulation across an attic floor beneath exposed wooden rafters.
Yellow fiberglass insulation fills the sloped ceiling between metal supports in an attic.
Pink batt insulation fills the spaces between vertical wooden wall studs.
An unfinished room has exposed framing with cream-colored spray foam filling the walls and roof.
Get a written estimate for blown-in insulation in your attic
Call (562) 307-9067 or send the form, and we'll reply within one business day to set up a free on-site estimate. I'll go through your attic and give you the estimate in writing, with no obligation to go ahead.
(562) 307-9067Questions about blown-in insulation in Cerritos
These are the questions I hear before a blown-in job, from what it costs to which material fits your attic. If yours isn't here, ask me when I'm out at your house.
How much does blown-in insulation cost in the Los Angeles area?
A blown-in insulation project around Los Angeles usually costs about $1,600 to $3,600 for the whole job, which is the going range in the area and not our price. Where your attic lands depends on its size, the inches already up there, how much sealing comes first and the material you choose. Your written estimate lists each step so you can see what you're paying for.
Is cellulose or fiberglass better for blown-in attic insulation?
Neither wins outright, because each one trades a weakness for a strength. Cellulose slows air moving through the layer better, but it breaks down if it gets soaked and settles 10 to 20 percent over time. Fiberglass settles 2 to 4 percent and isn't damaged for good by a soaking, though it does less to stop air, and it's the lighter choice for a mobile home ceiling, where cellulose's weight isn't recommended.
Do I need city approval for insulation work in Cerritos?
Yes, Cerritos's Planning Division has to approve any home improvement before work begins, and Building and Safety reviews the application or plans where the job calls for it. For projects the city's home improvement page doesn't list, the Community Development department gives the requirements at (562) 916-1201. Before we set a start date, I check with the city, and when a job needs a permit we handle the paperwork and the inspection.
Can blown-in insulation go over recessed lights?
Only when the fixture has an IC rating, short for insulation contact, because the cellulose makers' installation guidance lets insulation cover a recessed light or heater only then. You can check the label on your ceiling lights before we come out. Tell us what you find when you call, including any you can't read.
How do I compare blown-in insulation quotes?
Ask each contractor what density they'll install, whether air sealing is included and what code level they're aiming for. A bid with fewer bags can look cheaper because the fill gets "fluffed," blown below the maker's minimum density, and that layer lets air through and settles too much. It's also fair to ask about the license, since California has a contractor class just for insulation work, the C-2.
How long does blown-in insulation last?
Properly installed cellulose can work well for decades, according to the cellulose makers' trade group. The words that matter there are properly installed, which is why density and an even depth come first on our jobs.
Blown-in insulation in Cerritos and the cities nearby
California's Energy Code covers changes to existing homes, not just new ones, so the insulation we add in Cerritos is set to meet or beat current code, and your estimate says the level. We do the same attic work in Norwalk, Bellflower and the other cities listed here.